Read Sharp 37GT-25 Service Manual online
8
37GT-25H
PAGE
ADDRESS
DESCRIPTION
VALUE
C4
10
C5
02
C6
00
C7
30
C8
04
C9
PAGE MEMORY FOR LIST MODE PROGRAM 6
00
CA
10
CB
02
CC
00
CD
30
CE
04
CF
PAGE MEMORY FOR LIST MODE PROGRAM 7
00
1
D0 ∼ FF
RESERVED
FF
{
Page 100
{
Page 200
{
Page 300
{
Page 400
DEFAULT LIST MODE PAGES MEMORIZATION NOTE:
In page memory for LIST MODE, every digit is written in one nibble (4 bits).
The default values for programs 0
The default values for programs 0
∼7 are as follows: 100, 200, 300, 400.
Example: Program 0
NVM Position:
A0
A1
A2
A3
A4
A5
{
0
{
2
{
0
{
0
{
3
{
0
{
0
{
4
{
0
{
0
{
1
{
0
NVM Value:
•••••PIF/AGC Adjustement
•••••Screen Adjustement
3. Focus Adjustment
Set contrast to 10/10, brightness to 5/10 and
colour 0/10.
colour 0/10.
Apply mains voltage of 220V AC/50HZ to TV.
1.
Receive Philips pattern signal to a level between
60 and 80 dB
60 and 80 dB
µV.
2
.
3
.
Adjust focus potentiometer to obtain
maximum definition.
maximum definition.
4
.
1. AFT Adjustment
AFT must be adjusted to a fixed value of 40.
Receive the «COLOUR BAR» signal (Channel E-
12).
12).
Signal strength: 53 dBµV.
2. RF-AGC Cut-In Adjustment (I2C BUS)
Switch set OFF and ON again, setting is now
memorized.
memorized.
1
.
Enter into Service Mode.
2
.
Push CH
∧
until AGC appears on screen.
3
.
4
.
Push key of R/C.Setting is made
automatically. During this setting the colour bar
shall go from red to yellow. When setting is
finished, colour bar disappears and B-STOP
(bus stop)is shown on screen.
automatically. During this setting the colour bar
shall go from red to yellow. When setting is
finished, colour bar disappears and B-STOP
(bus stop)is shown on screen.
5
.
4. G2 Adjustment
the screen VR of FBT.
5
.
Check BKGD. If it is necessary adjust BKGD
according to instructions detailed in the next
page.
page.
Apply mains voltage of 220V AC/50HZ to TV.
1.
Receive the «MONOSCOPE» pattern signal to a
level between 60 and 80 dB
level between 60 and 80 dB
µV.
2
.
3
.
4
.
Enter into Service Mode. Press the TEXT key of
R/C and set to level.
R/C and set to level.
Set to the point where the raster disappears on
Click on the first or last page to see other 37GT-25 service manuals if exist.