XV-Z7000 (serv.man21). Complete (part1 part2) - Sharp Projector User Guide / Operation Manual. Page 6

If the projector starts to overheat due to setup problems or a dirty air filter, “TEMP.”
will appear in the lower-left corner of the picture. If the temperature continues to
rise, the lamp will turn off, the TEMPERATURE WARNING indicator on the projector
will flash, and after a 90-second cooling-off period the power will shut off. Refer
to “Lamp/Maintenance Indicators” on page 37, for details.

• The cooling fan regulates the internal temperature, and its performance is automatically

controlled. The sound of the fan may change during projector operation due to changes
in the fan speed.

Potential hazard of glass particles if lamp ruptures. Please have the nearest Sharp
Authorised LCD Projector Dealer or Service Centre replace lamp if rupture occurs.
See “Replacing the Projection Lamp” on pages 38 and 39.

BQC-PGC20X //1

C AUT I O N

A T T E NT I ON

Ⳮ35˚C

Ⳮ5˚C

For minimal servicing and to maintain high image quality, SHARP recommends
that this projector be installed in an area free from humidity, dust and cigarette
smoke. If the projector is used in these environments, the lens and filter will need
to be cleaned (or the filter replaced) more often, and internal cleaning may become
necessary. As long as the projector is regularly cleaned, use in these environments
will not reduce the overall operation life of the unit. Internal cleaning should only
be performed by a Sharp Authorised LCD Projector Dealer or Service Centre.
• Do not expose the projector to extreme heat or cold.

Operating temperature: 

Ⳮ5°C to Ⳮ35°C

Storage temperature: 

ⳮ20°C to Ⳮ60°C

• The mark shown on the left calls the user’s attention to a part of the projector

that emits intense heat during operation.

• The exhaust vent, the lamp cage cover and adjacent areas may be extremely

hot during projector operation. To prevent injury, do not touch these areas until
they have sufficiently cooled.

• Allow at least 10 cm of space between the cooling fan (exhaust vent) and the

nearest wall or obstruction.

• If the cooling fan becomes obstructed, a protection device will automatically

turn off the projector lamp. This does not indicate a malfunction. Remove the
projector power cord from the wall outlet and wait at least 10 minutes. Then
turn on the power by plugging the power cord back in. This will return the
projector to the normal operating condition.

When the projector is turned on after the lamp has been used for 900 hours,
“LAMP” will appear in the lower-left corner of the picture to advise you to replace
the lamp. See pages 38 and 39 for lamp replacement. If the lamp has been used
for 1,000 hours, the projector power will automatically turn off and the projector
will enter standby mode. Refer to “Lamp/Maintenance Indicators” on page 37,
for details.