XV-Z1E. Text - 1-42 - Sharp Projector Service Manual (repair manual). Page 3

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212

1

2

Lamp

Reflector

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212

1. Be sure to wear sun-glasses when servicing the

projector with the lamp
turned “on” and the top
enclosure removed.

2. Do not operate the lamp outside of the lamp housing.

3. Do not operate for more than 2 hours with the

enclosure removed.

1. Be sure to disconnect the AC plug when replacing

the lamp.

2. Allow one hour for the unit to cool down before

servicing.

3. R e p l a c e   o n l y   w i t h   s a m e   t y p e   l a m p .   Ty p e

CLMPF0042DE01 rated 75V/265W.

4. The lamp emits small amounts of UV-Radiation,  avoid

direct-eye contact.

5. The medium pressure lamp involves a risk of

explosion.  Be sure to follow installation instructions
described below and handle the lamp with care.

Since the lamp reaches a very high temperature during
units operation replacement of the lamp should be
done at least one hour after the power has been turned
off.  (to allow the lamp to cool off.)
Installing the new lamp, make sure not to touch the
lamp (bulb) replace the lamp by holding its reflector

2

.

[Use original replacement only.]

DANGER !  –– Never turn the power on without
the lamp to avoid electric-shock or damage of the
devices since the stabilizer generates high voltages
at its start.