XV-Z12000 (serv.man11). (9) Electrical adjustment - Sharp Projector Service Manual (repair manual). Page 4

1. Make the following settings.

Destination

Adjustment process Remote control setting

North America

S4

 Factory setting 4

Europe/Asia/

S3

Factory setting 3

Australia

1. Select OFF of LINE in the process mode and press

the ENTER key on the remote control.
The 5-minute display of the off timer appears and
check that the power is turned off about 6 seconds
after the display appears.

1. Make sure that the temperature is indicated.

1. Heat the thermistor with a

hair dryer.

1. Press the AUTO SYNC key on the remote control.

Check that the clock, phase, H-POS, V-POS can
be automatically adjusted.

1. Input the phase check pat-

tern of the VGA/S-VGA/
XGA signal to INPUT5.

Check that there is no abnormality with the screen.

To INPUT5 (DVI-I connector),
1. Input the color bar signal.
2. Input the gray scale signal.
3. Input the SMPTERP-133

signal.

1. Select the following group

and subject.
Group:

SSS

Subject: S4

(North America)
S3 (Europe/
Asia/Australia)

1. Set to the no-signal state.
2. Select the following group

and subject.
Group:

LINE

Subject: OFF