XV-C2E (serv.man2). Service manual part one - Sharp Projector Service Manual (repair manual). Page 8

1-6. Lift the back of the top cabinet slightly and

unhook the front cabinet.

(a)

First undo the left-hand hook.

(b)

Next undo the right-hand hook.

Now lift the top cabinet further up and
disconnect the leaf switch connectors
(LF) and (LL) as well as the operation
key unit flat cable (KE).  The top cabinet
is now free.

1-7. Tilt the front cabinet slowly in the arrow

direction to unhook it from the bottom cabinet.

(a)

First undo the left-hand hook.  Be careful
to tilt the front cabinet slowly.

(b)

Next undo the right-hand hook.

(c)

Disconnect the connector of the remote
control receiver PWB.

1-8. Disconnect the speaker connector (SP) and

remove the two lock screws.  Now detach the
side cover.

Note: Mount the air filter cover last.  Do not attempt to place the air filter cover first and then the top cabinet.

Because otherwise the air filter cover's lever and the top cabinet's leaf switch lever would interfere with each
other, thereby damaging the leaf switch.

1. Set the top cabinet over the bottom cabinet.

2. Press the front cabinet against the top and bottom cabinets to fit them together.

3. Press the rear cabinet against the top and bottom cabinets to fit them together.

4. Tighten up the screws into the rear cabinet.  Use the four 3-mm tapping screws and one M2.5 machine screw.

Be careful not to drive any tapping screw into the M2.5 screw hole.  The screw threads may be deformed.

5. Tighten up the tapping screws to fix the top and bottom cabinets.

6. Tighten up the M3 machine screws behind the air filter cover.

7. Finally mount the air filter cover.

Top Cabinet

(b)

1-6

1-6

(a)

1-6

(c)

1-7

1-8

1-7

(a)

(b)

1-7

(SP)

Front Cabinet

Side Cover Ass'y