Read Sharp XG-V10WE Handy Guide online
Product Safeguards
Version 1.1
Issue 04/2006
Issue 04/2006
58
SHARP ELECTRONICS (UK) LTD
PROJECTOR TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
Lamp Replacement
Note:
Since the lamp reaches a very high temperature during units operation replacement of the
lamp should be done at least one hour after the power has been turned off. (To allow the
lamp to cool off.)
Installing the new lamp, make sure not to touch the lamp (bulb) replace the lamp by holding
its reflector
2.
[Use original replacement only.]
lamp should be done at least one hour after the power has been turned off. (To allow the
lamp to cool off.)
Installing the new lamp, make sure not to touch the lamp (bulb) replace the lamp by holding
its reflector
2.
[Use original replacement only.]
DANGER! ––
Never turn the power on without the lamp to avoid electric-shock or damage
of the devices since the stabiliser generates high voltages at its start.
Since small amounts of UV-Radiation are emitted from an opening between the duct cover
and the lamp housing, it is recommended to place the LENS CAP on the opening during
servicing to avoid eye and skin exposure.
and the lamp housing, it is recommended to place the LENS CAP on the opening during
servicing to avoid eye and skin exposure.
WARNING:
High brightness light source, do not stare into the beam of light, or view
directly. Be especially careful that children do not stare directly in to the beam of light.
Click on the first or last page to see other XG-V10WE service manuals if exist.