XG-V10WE (serv.man8). Service Manual text - Page 1-59 - Sharp Projector Service Manual (repair manual). Page 17

4-1. Remove the two lock screws from the DVI connector.
4-2. Remove the five lock screws from the PC I/F PWB. Lift this PWB off the output PWB unit.
4-3. Remove the four lock screws from the cooling fan. Remove the lock screw from the output sub-PWB unit and

disconnect the connectors. Lift the cooling fan and the output sub-PWB unit off the output PWB unit.

4-4. Disconnect the connectors from the output PWB unit.
4-5. Remove the four stud bolts and eight lock screws from the output PWB unit. Lift and detach the output PWB

unit.

4-6. Disconnect the connector (SP) of the signal PWB unit.
4-7. Remove the eight lock screws from the side terminal board.
4-8. Remove the lock screw from the terminal cover and detach the terminal cover.
4-9. Remove the three lock screws from the grounding plate behind the terminal cover and detach the grounding

plate.

4-10. Detach the terminal board from the left-side panel. Lift the input PWB unit and the signal PWB unit off position.

4-2

4-3

4-6

4-5

4-4

4-10

4-5

4-5

4-5

4-5

4-7

4-9

4-7

4-1

4-8

(F4)

(F8)

(S8)

(RL)

(D) (EA)

(F5)

(BP)

(TP)

(KY)

(RP)

(S7)

(F7) (F6)

(S4)

(S3)

(AZ)

FRONT

(S5)

(GP)

(AS)
(F1)
(RE)
(L)

(F3)
(F2)

(RD)

(LL)

(EC)

PC I/F PWB unit

Cooling fan

Output sub-PWB unit

Output PWB unit

Output 
sub-PWB 
unit

Output 
PWB unit

Input PWB unit

Left-side panel

`

Signal PWB unit

`

 Note: When reassembling, fit

the projection of the
terminal PWB shield in
the positioning hole of the
left-side panel.