XG-P25XE (serv.man34). Basic operation - Sharp Projector User Guide / Operation Manual. Page 13

These functions allow you to reduce the power consumption. See page 

 for the procedure details.

Function to control the quantity of projected light. Select “

 (Low Power Mode)” or “

 (Standard Mode)” to

decrease or increase brightness, fan noise and power consumption.

Quantity of light is 85 %.
Power consumption is about 350 W.

Quantity of light is 100 %.
Power consumption is 380 W.

• “Power Save” mode is factory preset to “

 (Standard Mode)”.

• Even when selecting “

 (Low Power Mode)” in “Power Save” mode, fan noise may increase if internal temperature rises

enough to activate the cooling function.

This projector consumes power when using a monitor connected to the OUTPUT port for INPUT 1, 2 and a
computer connected to the RS-232C port. When not using these ports, “MNTR Out/RS232C” can be set to “

” to

reduce standby power consumption.

Standby power for Monitor Out/RS-232C
connection turned off.

Monitor Out/RS-232C on

• Set “MNTR Out/RS232C” to “

” when using the Sharp Advanced Presentation Software (supplied).

• “MNTR Out/RS232C” is factory preset to “

”, and “Auto Power Off” is factory preset to “

”.

When no input signal is detected for more than 15 minutes, the projector will automatically shut off. The on-screen
message, “Power OFF in 5 min.” will appear five minutes before the power is automatically turned off.

Power automatically shuts off after about 15
minutes of no signal input.

Automatic Power Shutoff disabled.