XG-P20XE (serv.man21). Section 5 Multiple function, Section 6 Maintenance troubleshooting, Section 7 Appendix - Sharp Projector User Guide / Operation Manual. Page 6

Unplug the power cord from the
AC socket.

Insert the tab on the end of the
filter cover into the filter cover
opening and press the filter
cover into position.

Grasp the air filter between your
fingers and lift it out of the filter
cover.

Turn over the projector. Press the
tab and lift open the filter cover
in the direction of the arrow.

Press POWER OFF. Wait until
the cooling fan stops.

Place the air filter underneath the
tabs on the filter frame.

• Be sure to remove the lamp cage by the handle. Be sure not to touch the glass surface of the lamp cage or the inside of

the projector.

• To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps below.
• Be sure to change the air filter during lamp replacement. The air filter comes packaged with the lamp unit.

It is recommended that the lamp be replaced after approximately 1,000 cumulative hours of use or when you
notice a significant deterioration of the picture and colour quality. Carefully change the lamp by following the steps
below.
If the new lamp does not light after replacement, take your projector to the nearest Sharp Authorised LCD Projector
Dealer or Service Centre for repair. Purchase a replacement lamp unit (lamp/cage module) of the current type
BQC-XGP20X//1 from your nearest Sharp Authorised LCD Projector Dealer or Service Centre. Then carefully
change the lamp by following the instructions below. If you wish, you may have the lamp replaced at your nearest
Sharp Authorised LCD Projector Dealer or Service Centre

• Potential hazard of glass particles if lamp ruptures. In case of lamp rupture, contact your nearest

• Do not remove the lamp cage directly after operation of the projector. The lamp may be extremely

Tab

Tab