Read Sharp XG-NV6XE (serv.man13) User Guide / Operation Manual online
35
●
Adjustments can still be made from the RS-232C Control utility
regardless of the difference in settings in the projector’s menu.
regardless of the difference in settings in the projector’s menu.
●
If you move to RS-232C Control during Presentation Transfer,
Capture & Transfer or Gamma Correction, Sharp Advanced
Presentation Software automatically confirms the adjustments on
the projector and shows them in the “RS-232C Control” window as
default settings.
Capture & Transfer or Gamma Correction, Sharp Advanced
Presentation Software automatically confirms the adjustments on
the projector and shows them in the “RS-232C Control” window as
default settings.
●
Also when you change the sheet of the “RS-232C Control” window
to proceed to the other projector adjustment, this confirmation is
performed. In this case, it will repeat at regular intervals afterwards
and the “RS-232C Control” window may show the settings on the
projector.
to proceed to the other projector adjustment, this confirmation is
performed. In this case, it will repeat at regular intervals afterwards
and the “RS-232C Control” window may show the settings on the
projector.
●
The Automatic Power Shutoff function will not operate when
performing RS-232C Control, although you turn “Auto Power Off”
ON in
performing RS-232C Control, although you turn “Auto Power Off”
ON in
the “Option” sheet
. This function operates during Presentation
Transfer, Capture & Transfer, or Gamma Correction.
Before Adjusting
●
Make sure that the “Economy Mode” on the projector is set in Mode
2 or Mode 4. Once you turn off the projector in Mode 1 or Mode 3,
you cannot turn it on again using the RS-232C Control utility.
2 or Mode 4. Once you turn off the projector in Mode 1 or Mode 3,
you cannot turn it on again using the RS-232C Control utility.
●
Only serial (RS-232C) cable communications is available for this
mode. Please connect a serial cable to the projector and the PC
mode. Please connect a serial cable to the projector and the PC
(page 9)
, select the correct COM Port on the PC, then proceed with
RS-232C Control.
1
Select the “RS-232C Control” mode.
See section “Opening Modes”
(page 17)
.
w
The “RS-232C Control” window will open.
2
Click the tab of the sheet including your desired
adjustment controller.
adjustment controller.
Adjusting and
Controlling
Click on the first or last page to see other XG-NV6XE (serv.man13) service manuals if exist.