XG-NV33XE (serv.man2). Service Manual text - Page 1-55 - Sharp Projector Service Manual (repair manual). Page 7

REMOTE CONTROL SIGNAL

TRANSMITTER

WIRED REMOTE CONTROL

INPUT (3.5 mm Minijack)

LASER LIGHT WINDOW

Laser light shines out of this window.

LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT

RADIACION LASER
NO MIRE AL RAYO
PRODUCTO LASER CLASE 2

RAYONNEMENT LASER
NE PAS REGARDER DANS LE FAISCEAU
APPAREIL À LASER DE CLASSE 2

When the remote control cannot be used due to the range or
positioning of the projector (rear projection, etc.), connect the
optional cable from the Wired Remote Control Input jack on the
remote control to the Wired Remot Input on the rear of the
projector.

Note:
• The signal transmitter does not function when the optional cable is

connected to the remote control.

The laser pointer on the remote control emits a
laser bean from the laser light window shown in
the figure on the left. The laser emitted is a class
II laser; therefore, do not look into the laser
window or shine the laser beam on yourself or
other people.
The two marks on the left are the caution labels
for the laser beam.
Always use the laser pointer at temperatures
beween +5

°

C and +40

°

C.

Remove the battery cover as shown and insert four AA size
batteries marking sure their polarities match the (+) and (–) marks
inside the battery compartment.

Note:
Incorrect use of batteries may cause them to leak or burst.
• Insert the batteries with the (+) and (–) polarities as indicated.
• Remove the batteries if the remote control will not be operated for an

extended period of time.

• Maintain the batteries in a clean condition.
• Do not mix different brands of batteries. The life expectancy of the

new batteries will be shortened and the old batteries may leak.

• When the batteries have been used up, remove them immediately to

prevent leakage and damage. Leaked battery fluid may irritate the
skin. Remove any battery fluid by wiping with a cloth.

• Due to storage conditions and the shelf life of the supplied batteries,

they may run out after a short time. If so, replace them with new
batteries as soon as possible.

Press in and
downward on
the arrow
mark and
remove.

Insert the side
tabs into their
slots and
press in the
cover until
properly
seated.

Use the remote control as shown in the figures on the left.

Note:
• The signal from the remote control can be reflected off the screen for

easy operation. However, the effective distance of the signal may
differ due to the screen material.

Max. distance: 7m

30

°

45

°

30

°

30

°