XG-NV33XE (serv.man2). Service Manual text - Page 1-55 - Sharp Projector Service Manual (repair manual). Page 11

2-4. While pressing the top center at both sides of the bottom cabinet, pull the ends of the top cabinet outward to

unhook it. Slowly lift the back of the top cabinet, disconnect the operation key PWB connector (KY) and the
speaker connector (SP), and take up and away the top cabinet.

2-5. Remove the lock screw off the video terminal cover and detach the video terminal cover.

2-1. Remove the five lock screws off the rear cabinet.
2-2. Remove the ten lock screws from the rear cabinet and the terminal plate. Detach the rear cabinet from the

bottom first (because it is hooked at the top).

2-3. Remove the four lock screws off the top cabinet.

2-3

2-3

2-3

2-1

2-1

2-2

2-2

2-3

2-2

(for XG-NV33XM, 
XG-NV330XA as well 
as Australia and 
NewZealand versions of 
XG-NV33XE)

(KY)

(SP)

2-4

2-5

Operation Key Unit

Top Cabinet

Rear Cabinet

Video Terminal Cover

Video Board Unit (for XG-NV3XM, XG-NV30XA
as well as Australia and NewZealand
versions of XG-NV3XE)