XG-NV21SE (serv.man3). Introduction and contents, , Removing of major parts - Page 1-14 - Sharp Projector Service Manual (repair manual). Page 3

1. Be sure to wear sun-glasses when servicing the

projector with the lamp
turned “on” and the top
enclosure removed.

2. Do not operate the lamp outside of the lamp housing.

3. Do not operate for more than 2 hours with the

enclosure removed.

1. Be sure to disconnect the AC plug when replacing

the lamp.

2. Allow one hour for the unit to cool down before

servicing.

3. Replace only with same type lamp.  Type

CLMPF0056CE01 or BQC-XGNV6XE/1 rated 65V/
150W.

4. The lamp emits small amounts of UV-Radiation,

avoid direct-eye contact.

5. The medium pressure lamp involves a risk of

explosion.  Be sure to follow installation instructions
described below and handle the lamp with care.

1234567890123456789012345678901212345678901234

1234567890123456789012345678901212345678901234

1234567890123456789012345678901212345678901234

1234567890123456789012345678901212345678901234

1234567890123456789012345678901212345678901234

1234567890123456789012345678901212345678901234

Since the lamp reaches a very high temperature
during units operation replacement of the lamp should
be done at least one hour after the power has been
turned off.  (to allow the lamp to cool off.)
Installing the new lamp, make sure not to touch the
lamp (bulb) replace the lamp by holding its reflector

2

 .

[Use original replacement only.]

DANGER !  –– Never turn the power on without
the lamp to avoid electric-shock or damage of the
devices since the stabilizer generates high
voltages at its start.

1

2

Lamp

Reflector

Since small amounts of UV-Radiation are emitted
from an opening between the duct cover and the
lamp housing, it  is recommended to place the LENS
CAP on the opening during servicing to avoid eye
and skin exposurem (Fig. 1).

Note: Please obtain a lens cap before servicing a

models XG-NV21SE/SM/SA that is received
without one.

LENS CAP