Read Sharp XG-MB70X Handy Guide online
Lamp Replacement Procedure
Version 1.3
Issue 04/2006
Issue 04/2006
11
SHARP ELECTRONICS (UK) LTD
PROJECTOR TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
Removing and Installing the Lamp Unit
Note
•
Ensure the lamp unit is
removed using the
handle. Ensure the glass
surface of the lamp unit
or the insides of the
projector are not
touched.
removed using the
handle. Ensure the glass
surface of the lamp unit
or the insides of the
projector are not
touched.
•
To avoid injury to
yourself and damage to
the lamp, ensure to carefully follow the steps below.
yourself and damage to
the lamp, ensure to carefully follow the steps below.
•
Do not loosen other screws except for the lamp unit cover and lamp unit. (Only the silver
screws are loosened).
screws are loosened).
1.
Press “STANDBY” on the projector to turn off the power.
•
Wait until the cooling fan stops.
Warning!
•
Do not remove the lamp unit from the projector right after use.
The lamp will be very hot and may cause burn or injury.
The lamp will be very hot and may cause burn or injury.
2.
Disconnect the power cord.
•
Unplug the power cord from the AC socket.
•
Leave the lamp until it has fully cooled down (about 1 hour).
Click on the first or last page to see other XG-MB70X service manuals if exist.