Read Sharp XG-MB70X (serv.man26) User Guide / Operation Manual online
-7
Setting up the Projector Network Environment
1. Connecting the Pro-
jector to a Computer
Establishing a one-to-one connection from the
projector to a computer. Using a LAN cable
(Category 5, cross-over type) you can config-
ure the projector via the computer.
projector to a computer. Using a LAN cable
(Category 5, cross-over type) you can config-
ure the projector via the computer.
1
Disconnect the computer’s LAN
cable from the existing network.
cable from the existing network.
2
Connect a LAN cable (a UTP
cable, Category 5, cross-over
type) to the projector’s LAN ter-
minal and connect the other end
of the cable to the computer’s
LAN terminal.
cable, Category 5, cross-over
type) to the projector’s LAN ter-
minal and connect the other end
of the cable to the computer’s
LAN terminal.
3
Turn on the projector.
4
Turn on the Computer.
Info
Confirm that the LINK LED on the rear of the
projector illuminates. If the LINK LED does not
illuminate, check the following :
projector illuminates. If the LINK LED does not
illuminate, check the following :
• The LAN cable is properly connected.
• The power switches of both the projector
• The power switches of both the projector
and the computer are on.
LAN cable
(cross-over type, commercially available)
ON
ON
A LAN cable being
connected to the network
connected to the network
This completes the connection. Now proceed to “2. Setting an IP Address for the Com-
puter”.
puter”.
XG-MB70X_E_P02_19.p65
04.8.6, 2:23 PM
7
Click on the first or last page to see other XG-MB70X (serv.man26) service manuals if exist.