XG-C40XE (serv.man18). Part 2 - Sharp Projector User Guide / Operation Manual. Page 4

You can adjust the height of the image by raising the
projector with the foot release.

1 Press the foot release and lift the projector to the

desired angle. (Adjustable up to approximately
5° from the standard position.)

2 Remove your hand from the foot release. Once

the adjustment foot has locked in position, release
the projector.

3 If the screen is at an angle, the adjuster can be

used to adjust the angle of the image. (Adjustable
up to approximately 1° from the original position.)

1

3

Foot release

While holding the projector, press the foot release and slowly lower the projector to its original position.

• When an adjustment is made, the image may become distorted (keystoned), depending on the relative positions of the projector and the

screen.

• Do not press the foot release when the adjustment foot is extended without firmly holding the projector.
• Do not hold the lens when lifting or lowering the projector.
• When lowering the projector, be careful not to get your fingers caught in the area between the adjustment foot and the

projector.

• Optimal image quality can be achieved when the projector is positioned perpendicular to the screen with all feet flat and level.

• When the distance between the projector and screen

is not sufficient for normal rear projection, you can
use a mirror to reflect the image onto the screen.

• Place a mirror (normal flat type) in front of the lens.
• Project the normal image onto the mirror.
• The image reflected from the mirror is projected onto

the translucent screen.

• Place a translucent screen between the projector and

the audience.

• Use the projector’s menu system to reverse the

projected image. (See page 44 for use of this
function.)

• When using a mirror, be sure to carefully position both the projector and the mirror so the light does not shine into the eyes of

the audience.

• It is recommended that you use the optional Sharp ceiling-

mount bracket for this installation.

• Before mounting the projector, contact your nearest Sharp

Authorised LCD Projector Dealer or Service Centre to obtain
the recommended ceiling-mount bracket (sold separately).
(AN-C30T ceiling-mount bracket, AN-TK201/202 extension
tube for AN-C30T.)

• When the projector is in the inverted position, use the upper

edge of the screen as the base line.

• Use the projector’s menu system to select the appropriate

projection mode. (See page 44 for use of this function.)

XG-C40XE/CD (E)-c

01.8.1, 5:52 PM

21