PG-MB60X (serv.man12). p26-32 Electrical Adjustments - Sharp Projector Service Manual (repair manual). Page 5

1. Make the following settings.

Destination

Process

Remote control

adjustment

adjustment

USA

SS4

Factory setting at 4

China

SS6

Factory setting at 6

Europe and

the Other

SS3

Factory setting at 3

Contries

∗

Although it is possible for the process OUT to exit using the process menu, the IN/OUT toggle command is also
available considering the existing specification.

1. Calling and quitting

With the menu not displayed, press the "ENTER", "ENTER", "VOL+", "VOL-", "ENTER", "ENTER" and "MENU"
keys on main unit.

2. Others

Press the S3563 process key (toggle) on the main PWB to call and quit the process menu.

Note: When adjusting in the process mode, set a signal with a vertical frequency of 60 Hz or no signal. (May not be

properly adjusted with other signals.)

1. Resetting procedure

In Stand-by, run this command to clear the operating time of the lamp to 0 and turn on the power.
Press and hold "DOWN", "ENTER", and "MENU", and then press the "ON" key of the set.

1. Disabling procedure

With System-Lock input window onscreen, press the "MENU", "ENTER", "ENTER", "MENU", "ENTER", "ENTER"
and "MENU" keys, in this order, on the remote controller.

1. Connect to a PC with a

USB cable.

1. Check that advance/reverse operation on PC screen

is possible by using remote control.