Read Sharp PG-M25XE (serv.man30) User Guide / Operation Manual online
Image Projection
▼Projector indicators
LAMP REPLACEMENT indicator
POWER indicator
POWER button
INPUT
button
button
INPUT button
POWER button
▼Keycode input box
-34
Volume
buttons
buttons
Volume button
Basic Procedure
Connect the required external equipment to the pro-
jector before operating the following procedures.
Details are found in the projector operation manual.
jector before operating the following procedures.
Details are found in the projector operation manual.
Info
• The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on
to another language, reset the language ac-
cording to the procedure on
page 37
.
1
Plug the power cord into the wall outlet.
• The POWER indicator illuminates up in red,
and the projector enters standby mode.
2
Press
on the projector or
on the GyroRemote.
• The POWER indicator illuminates in
green. After the LAMP REPLACEMENT
indicator illuminates, the projector is
ready to start operation.
indicator illuminates, the projector is
ready to start operation.
Note
• The LAMP REPLACEMENT indica-
tor illuminates, indicating the status
of the lamp.
of the lamp.
Green: The lamp is ready.
Green blinking: The lamp is
Green blinking: The lamp is
warming up.
Red blinking: The lamp should
be replaced soon.
Red: The lamp should be
replaced immediately.
• If the power is turned off and imme-
diately switched on again, the LAMP
REPLACEMENT indicator may take
time to illuminate.
REPLACEMENT indicator may take
time to illuminate.
3
When “Anti-Theft” (see
page 102
) is
set, the keycode input box will appear.
• Enter the keycode.
Note
• When entering the keycode, press
the buttons previously set on the
projector or the GyroRemote.
projector or the GyroRemote.
Info
• When “Anti-Theft” is set, enter the
keycode or the input display will not ap-
pear. Even when the signal is input, the
display will not appear. (See
pear. Even when the signal is input, the
display will not appear. (See
page 102
.)
Click on the first or last page to see other PG-M25XE (serv.man30) service manuals if exist.