Read Sharp PG-B10S (serv.man33) User Guide / Operation Manual online
-21
Projection
2
Press ', ", \ and | to adjust
the Keystone Correction.
•
You can also adjust the Keystone Cor-
rection using the
,
,
and
buttons on the projector.
Note
•
Press
to return to the default setting.
•
Straight lines or the edges of images may
appear jagged while adjusting the image.
appear jagged while adjusting the image.
3
Press
.
•
The on-screen display of the Keystone
Correction mode will disappear.
Correction mode will disappear.
•
You can also use
on the projector.
Note
•
You can use the same settings used in
NORMAL mode 4:3 for 16:9.
NORMAL mode 4:3 for 16:9.
Turning the Power off
(Putting
the Projector into the Standby Mode)
1
Press
on the projector or
STANDBY
on the remote control, then
press that button again while the
confirmation message is dis-
played, to put the projector into
the standby mode.
confirmation message is dis-
played, to put the projector into
the standby mode.
Note
•
If you accidentally pressed
or
STANDBY
and do not want to put the pro-
jector into the standby mode, wait until
the confirmation message disappears.
the confirmation message disappears.
2
Unplug the power cord from the AC
outlet after the cooling fan stops.
outlet after the cooling fan stops.
Info
•
Do not unplug the power cord during pro-
jection or cooling fan operation. The cool-
ing fan in this projector continues to run
for about 90 seconds after the projector
enters the standby mode. This can cause
damage due to rise in internal tempera-
ture, as the cooling fan also stops.
jection or cooling fan operation. The cool-
ing fan in this projector continues to run
for about 90 seconds after the projector
enters the standby mode. This can cause
damage due to rise in internal tempera-
ture, as the cooling fan also stops.
Compresses
lower side.
lower side.
Compresses
upper side.
upper side.
STANDBY
button
button
Click on the first or last page to see other PG-B10S (serv.man33) service manuals if exist.