Read Sharp PG-A20X (serv.man8) Service Manual online
2-2. Remove the six lock screws from bottom of the set.
2-3. Remove the two hooks and detach the top body.
1-2. Loosen the two screws. Hold the lamp unit by the handle and pull it in the direction of allow.
3-2. Remove all the connectors from main PWB.
3-3. Detach the main PWB.
3-4. Remove the two screws and detach the operation
4-2. Detach the Power/Ballast holder cover.
4-3. Remove all the connectors from optical mechanism unit.
4-4. Remove the nine screws and take out of the optical mechanism unit and the exhaust cover.
4-5. Detach the R/C receiver PWB.
4-6. Detach the Speaker.
5-2. Remove a screw and take out of the power/ballast assembly.
5-3. Detach the bottom shield and shield cover.
5-4. Remove a connector and detach the AC inlet.
5-5. Remove the two hooks and take out of the ballast unit from power/ballast case. Remove the all connectors
5-7. Remove the two screws and cooling fan.
the gap between the upper shield and holder.
is visible from the square hole on the upper shield.
and holder since the insu-
lating distance to the bal-
last PWB becomes inad-
6-2. Remove a screw and detach the leaf switch.
6-3. Remove a screw and two hooks. Detach the spacer B. Take out of the fan LCD R/G-intake duct B assembly.
6-4. Remove a screw and detach the fan LCD R/G.
6-5. Remove the two screws and detach the fan LCD B.