Read Sharp MX-PEX1 (serv.man3) Service Manual online
71
Error codes and conditions
System software installation
USB flash drive method:
Fiery X3eTY2 remains on
for 30 minutes (or longer)
after beginning
installation
for 30 minutes (or longer)
after beginning
installation
One of the following:
• Fiery X3eTY2 is still connected to
the MFP, and the MFP is powered
on
on
• Service switches are set to
Service mode
• Faulty HDD
• Faulty motherboard
• Faulty USB flash drive
1. Make sure that the MFP is powered off and that all cables
between the Fiery X3eTY2 and the MFP are disconnected.
2. Make sure that the Fiery X3eTY2 service switches are set
to Normal mode (away from “ON”).
If the service switches are in Service mode (toward
“ON”), power off the Fiery X3eTY2, set the switches to
Normal mode, power on, and allow the installation to
resume.
“ON”), power off the Fiery X3eTY2, set the switches to
Normal mode, power on, and allow the installation to
resume.
3. Check the LED on the USB flash drive.
If the LED is not blinking (remains off or solid), the flash
drive may be improperly seated. Power off the
Fiery X3eTY2 and reseat the flash drive; then power on
and allow the installation to resume.
drive may be improperly seated. Power off the
Fiery X3eTY2 and reseat the flash drive; then power on
and allow the installation to resume.
4. Reseat the power and data cables to the HDD.
5. Replace the HDD data cable.
6. Replace the HDD.
7. Clear the CMOS and power-up settings (see page 81).
8. Replace the motherboard.
9. Replace the CPU.
10. Retry the installation using a different USB flash drive.
USB flash drive method:
During installation, the
LED on the flash drive
remains off or solid (not
blinking)
LED on the flash drive
remains off or solid (not
blinking)
One of the following:
• Faulty or improperly seated USB
flash drive
• Faulty motherboard
• Faulty HDD
1. Power off the Fiery X3eTY2 and reseat the flash drive; then
power on and allow the installation to resume.
2. Retry the installation using a different USB flash drive.
3. Clear the CMOS and power-up settings (see page 81).
4. Replace the motherboard.
5. Reseat the power and data cables to the HDD.
6. Replace the HDD data cable.
7. Replace the HDD.
T
ABLE
B
Fiery X3eTY2 error codes and conditions (Continued)
Symptom
Possible cause
Suggested action
Click on the first or last page to see other MX-PEX1 (serv.man3) service manuals if exist.