MX-NB10 (serv.man6). Service Manual. - Sharp Copying Equipment Service Manual (repair manual). Page 6

MX-NB10

SPECIFICATIONS

1 – 5

Sender name: Use MFP product name.

Date & Time: Date and time at which file is sent

Session page counter: Image send counter

Unique identifier: Automatically created based on the information of the

date and time and image send counter.

Example: MX-M200D_20000620_155114_0057_06a3f3393948.pdf

Can be freely set.

Default: Scanned image. device name: MX-XXX (MFP product name)

Example: Scanned image. device name: MX-XXX

The following messages are added to the image send mail.

Device name: Freely set

Model: MFP product name

Location: Freely set

File type: File type of send image

Resolution: Resolution of send image

Example: Device name: MX-XXX

Model name: MX-XXX

Location: D2) Planning dept.

File type: PDF MMR (G4)

Resolution:200 dpi x 200 dpi

• The mail address registered for each destination can be selected

from the mail address which is searched using LDAP.

•  The information for each recipient includes the recipient name, IP address

or mail address, scanning size, format type, and scan parameter.

• The scanning size is the size of the document sensed or predeter-

mined by the main unit(copier). 

• If there is no information available about the document size from the

main unit(copier), scanning is performed according to the scanning
size predetermined in the destination registration section in advance.
However, a detected or predetermined document size takes prece-
dence over the information predetermined.

• This unit should be connected to the USB port (USB-2) on the dual

function board of the main unit(copier).

Network setups should be performed by the system administrator. Use
a setup tool such as TCP/IP, Netware, Ether Talk or Web interface.

The network expansion kit can be installed by setting up NIC, installing
a printer driver with the total installer, and installing Sharpdesk. 

The network expansion kit printer is connected only through the net-
work. The port setup required for installing a printer driver is the network
only. The following items should be set up.

1) Search for the network expansion kit on the network and select the

network expansion kit you want or enter the IP address of the appli-
cable network expansion kit to create a TCP/IP port.

2) Install the driver to the created port.

When the setup of the above client PC is completed and the printer is
set to "Windows shared printer," other client PCs can select this
printer shared port and then proceed to installation of the driver.

1) Requirements for connecting network expansion kit

•  Dual function board mounted model is recommended

•  Dual function board is surely required for network scanning

2) Connection to the main unit(copier)

•  When Dual function board is used, connects with USB2.0 port of a

main unit(copier).

3) Power supply

Supplied by the main unit