MX-MF11. All Sections - Sharp Copying Equipment Specification (repair manual). Page 5

MX-MF11  REPLACEMENT AND ADJUSTMENT  3 – 2

9)

Remove the bottom plate rear right cover [B] (screw x 1).

10) Remove the bottom plate rear left cover [C].

11) Remove the plate [D] and shaft (screw x 1, stopper x 1).
12) Separate the top and bottom of the feed tray

(connector x 2, stopper x 1).

1)

Pull off the pick-up roller cover [A].

2)

Pull off the separation roller cover [B].

3)

Remove the pick-up roller [C] (stopper x 1).

4)

Remove the feed roller [D] (stopper x 1).

5)

Remove the separation roller [E] (stopper x 1).
NOTE: After re-installing the feed roller, make sure that it
rotates clockwise.

6)

Reset the PM count to zero for the new rollers.

1)

Remove the rear cover. (see 2.)

2)

Remove the bypass tray PCB [A] (connector x 9, screw x 2,
standoffs x 2).
NOTE: Before disconnecting CN210 and CN211, mark either
connector with a marker to make sure that you re-connect
them correctly. The shapes of these connectors are the same
and the wires are the same color.

1)

Remove the rear cover. (see 2.)

2)

Remove the paper feed motor [A] (screw x 3, spring x 1, timing
belt x 1, connector x 1).

3)

Remove the transport motor [B] (screw x 3, spring x 1, timing
belt x 1, connector x 1)

[A]

[B]

[C]

[D]

[E]

Bypass tray PCB [A]

Screw

Paper feed motor [A]

Transport motor [B]

Screw

Screw