MX-MF11 (serv.man5). Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 6

MX-MF11  REPLACEMENT AND ADJUSTMENT  3 – 3

1)

Remove the rear, front, and top covers. (see 2.)

2)

Remove the paper feed bracket [A] (step screw x 1, screw x 1).

3)

Remove the paper feed sensor [B] (hooks x 3, connector x 1)

4)

Remove the lift sensor bracket [C] (screw x 1).

5)

Remove the lift sensor [D] (hooks x 3, connector x 1).

1)

Remove the rear, front, and top covers. (see 2.)

2)

Remove the pick-up solenoid [A] (screw x 2, connector x 1,
harness clamp x 1)

NOTE: When re-installing the solenoid, make sure that the arm of

the solenoid is positioned above and in contact with the
plate of the pick-up roller shaft below. To confirm correct
installation, manually move the solenoid to the left and
right. When the solenoid plunger is moved, the pick-up
roller should move up and down smoothly.

1)

Remove the feed tray and separate the top and bottom. (see
3.)

2)

Turn over the top half of the feed tray [A] then lay it on a flat
surface.

3)

Remove the cable cover [B] (hooks x 2).

4)

Paper end sensor bracket [C] (hook x1).

5)

Paper end sensor [D] (hooks x 2, connector x 1).

6)

Paper length sensor bracket [E] (hook x 1, screw x 1).

7)

Paper length sensor [F] (hooks x 2, connector x 1).

8)

Paper width switch [G] (screw x 1, harness clamp x 1, connec-
tor x 1).

[A]

[B]

[A]

[C]

[D]

[E]

[F]

[G]