Read Sharp MX-MF11 (serv.man5) Service Manual online
MX-MF11 REPLACEMENT AND ADJUSTMENT 3 – 1
MX-MF11
Service Manual
[3] REPLACEMENT AND
ADJUSTMENT
1. Opening the bypass tray
1)
Pull in the direction indicated by the arrow at the front left
cover.
cover.
CAUTION: When moving the LCT with the bypass unit attached,
grip and push the body of the LCT unit. To avoid dam-
aging the bypass tray, never attempt to push or rotate
the assembled units by pulling or pushing on the bypass
tray.
aging the bypass tray, never attempt to push or rotate
the assembled units by pulling or pushing on the bypass
tray.
2. Bypass tray covers
1)
Open the bypass tray. (see 1.)
2)
Front cover [A] (screw x 1).
3)
Rear cover [B] (screw x 1).
4)
Pull off the pick-up roller cover [C].
5)
Top cover [D] (screw x 2).
3. Tray lift switch, feed tray
1)
Open the bypass tray. (see 1.)
2)
Remove the covers. (see 2.)
3)
Use the tip of a screwdriver to remove the tray lift switch cover
[A].
[A].
4)
Remove the tray lift switch [B] (screw x 1, hook x 1, standoff x
1, connector x 1).
1, connector x 1).
5)
Disconnect the tray lift switch connector [C].
6)
Disconnect the paper width switch [D] (connector x 2, harness
clamp x 1).
clamp x 1).
7)
Remove the feed tray [E] (screw x 4).
8)
Pull out the extension tray [A].
NOTE: The extension tray must be removed to separate the
top and bottom of the bypass feed tray.
NOTE: The extension tray must be removed to separate the
top and bottom of the bypass feed tray.
[A]
[A]
[B]
[D]
[C]
[A]
[B]
[C]
[D]
[E]
[A]
Click on the first or last page to see other MX-MF11 (serv.man5) service manuals if exist.