Read Sharp MX-M950 / MX-MM1100 (serv.man40) Service Manual online
MX-M1100 MAINTENANCE 9 – 82
28) Check the torque limiter (a) at every 500K.
29) Remove the screw (a). Remove the E-ring (b), and slide the
bearing (c).
30) Remove the shaft (a), and replace the torque limiter (b) (when
DSPF counter value reaches 800K from the beginning of use).
31) Remove the screw (a), and remove the mounting plate (b).
Disconnect the connector (c). Clean the DSPF paper exit sen-
sor (d) at every 500K.
sor (d) at every 500K.
32) Open the DSPF unit (a), and clean the platen roller (b), the
scanning section paper guide (c), and the document mat (d) at
every 500K.
every 500K.
33) Open the lower door (a), and clean the transport roller 3 (b),
the transport roller 4 (c), and the back surface scanning glass
lower (d) at every 500K, and check the DSPF paper pass sen-
sor 7 (e) at every 200K. Clean the paper guides at every 500K.
lower (d) at every 500K, and check the DSPF paper pass sen-
sor 7 (e) at every 200K. Clean the paper guides at every 500K.
a
a
a
b
c
a
b
a
b
c
d
a
b
c
d
a
b
c
d
e
Click on the first or last page to see other MX-M950 / MX-MM1100 (serv.man40) service manuals if exist.