Read Sharp MX-M950 / MX-MM1100 (serv.man18) Service Manual online
MX-M1100 PAPER TRANSPORT SECTION F – 12
* Install so that the white dot (a) on side of the sensor faces
toward the marking (b) and so that the white dot (a) can be
seen from the slit.
seen from the slit.
4)
Disconnect the connector (a). Remove the screw (b), the mylar
(c), and the plate (d). Remove the double feed sensor (receiv-
ing) (e).
* When installing the double feed sensor (receiving), confirm
(c), and the plate (d). Remove the double feed sensor (receiv-
ing) (e).
* When installing the double feed sensor (receiving), confirm
that the mark (f) on top of the sensor is "R".
* When installing the double feed sensor (receiving), arrange
so that the bottom line (a) of the square encircling the "R"
mark on the holder is on the same side of the white dot (b)
on the back of the sensor. (Within
mark on the holder is on the same side of the white dot (b)
on the back of the sensor. (Within
± 10 degrees)
* Mylar attachment procedure
Hold the harness so that the Mylar bend section (a) faces
upward, and cross the cut sections (b) and attach it.
When fixing the Mylar with a screw, allow looseness in the
harness section (c).
upward, and cross the cut sections (b) and attach it.
When fixing the Mylar with a screw, allow looseness in the
harness section (c).
5)
Remove the screw (a), and remove the PS motor unit (b).
6)
Remove the screw (a), and remove the cover (b). Disconnect
the connector (c).
the connector (c).
7)
Open the harness holder (a), and remove the harness (b).
BK
b
a
d
c
b
e
a
R
f
R
a
b
a
b
c
a
b
a
a
c
c
b
a
b
Click on the first or last page to see other MX-M950 / MX-MM1100 (serv.man18) service manuals if exist.