MX-M850 (serv.man14). Details of Each Section - C DSPF Section - Sharp Copying Equipment Service Manual (repair manual). Page 14

MX-M1100  DSPF SECTION  C – 14

3)

Loosen the screw (a). Slide the DSPF transport motor (b) to
reduce the tension of the belt (c). Tighten the screw (a).
* When assembling, set the spring in the compressed state by

the same procedure to apply a tension to the belt. 

4)

Remove the E-ring (a) and the bearing (b). Remove the trans-
port roller 1 unit (c) and the transport roller 2 unit (d).

5)

Remove the E-ring (a), the pulley (b), the pin (c), and the bear-
ing (d) from the transport roller 1 / transport roller 2 (e).

1)

Remove the front cabinet and the rear cabinet.

2)

Disconnect the connector (a), the step screw (b), and the E-
ring (c). Remove the upper door (d).

b

c

a

a

b

c

a

b

c

d

a

b

d

e

c

A

DSPF paper pass sensor 5

C - 14/ (1)

B

DSPF paper pass sensor 6

C

No. 2 resist roller

D

DSPF paper pass sensor 7

C - 16/ (2)

E

Transport roller 3

C

A

E

B

D

a

d

c

b