MX-M700U (serv.man8). Administrator Settings Guide - Sharp Copying Equipment User Guide / Operation Manual. Page 18

This section explains the administrator settings for copy mode.

"Copy settings" consists of the following settings:

● Initial status settings
● Exposure adjustment
● Rotation copy setting
● Add or change extra preset ratios
● Initial margin shift setting
● Erase width adjustment

*1

● Card shot settings

● Initial tab copy setting
● Setting a maximum number of copies
● Disabling deletion of job programs
● Disabling of bypass-tray in duplex copy
● Disabling of auto paper selection

*1 Default settings selected with these settings apply

to all functions of the machine (not just the copy
function).

The copy settings revert to the default settings when
the power switch is turned on, when the [CA] key is
pressed, or when the auto clear time elapses. This
setting is used to change the default settings, or return
changed default settings to the initial factory default
settings.
Defaults for the following copy settings can be
changed:
Paper tray/Exposure tray/Copy ratio/2-sided copy/Out
put (Auto/sort/staple sort/group, output tray)

This setting is used to adjust the exposure level when
"Auto" is used for the copy exposure.
The factory setting is "5". "1" indicates lighter density
and "9" indicates darker density on the touch panel.

This setting is used to have the image of an original
automatically rotated when the orientation of the
original does not match the orientation of the copy
paper.
(Rotation copy will function only if the auto paper select
or auto image mode has been selected.)

When using AB sizes, there are normally five preset
enlargement ratios and five preset reduction ratios.
When using inch sizes, there are normally four preset
enlargement ratios and four preset reduction ratios.
This  setting allows you to add two more preset
enlargement ratios and two more preset reduction ratios.
This setting also allows you to change a preset ratio.

This setting is used to set the initial margin shift
amount.
The initial margin shift amount can be set from 0 mm to
20 mm (0" to 1") in increments of 1 mm (1/8").
Normally the margin shift is set to 10 mm (1/2") for both
the front and back of the paper.

This setting is used to set the initial width of edge erase
copying.
The edge erase width can be set from 0 mm to 20 mm
(0" to 1") in increments of 1 mm (1/8").
The edge erase and centre erase widths are normally
set to 10 mm (1/2").

This setting is used to set the initial original size for the
card shot function.
Enter the X dimension (width) first and then the Y
dimension (length).
Both the X and Y dimensions can be set from 25 mm to
210 mm (1" to 8-1/2") in increments of 1 mm (1/8").

If this setting is used to change the default setting for
the duplex function to other than "one-sided" 
"one-sided" and the automatic document feeder fails
or is disabled*, the setting will revert to "one-sided"

 "one-sided".

* DISABLING OF DOCUMENT FEEDER (page 11)

DISABLING OF DUPLEX (page 11)

To copy an A5 or 5-1/2" x 8-1/2" size original onto
A5R or 5-1/2" x 8-1/2"R paper, this setting must be
enabled.

Only an added preset ratio can be changed.