Read Sharp MX-M654N / MX-M754N (serv.man2) Handy Guide online
SHARP
REPAIR HINTS
61
OUTPUT DEVICE
MX-FN22
FSS203_N jams
Check/replace the FSS203 sensor (0CWFK21772001).
Reform the bracket supporting FSS203 sensor upwards.
Within the Saddle Tray Unit, check if the paper lead edge
is catching the bracket/frame that sits directly above the
bracket holding the FSS203 sensor.
Reform the bracket/plate to ensure there is a sufficient
and even gap (front to rear) across the plate/bracket to
allow the paper lead edge to pass through unobstructed.
MX-FN21
MX-FN22
MX-FN22
When copying multiple pages of a
single original/page using the DSPF,
all pages are output using Offset
mode (even though it is unchecked)
Change SIM55-03 SW9-4 from 1 (Offset) to 0 (no Offset)
MX-FN21
MX-FN22
MX-FN22
Please lower the paper guide of the
finisher message
On the Finisher, push down the exit roller assembly (just
above the exit tray) in the centre section, which is
indicated with a green marker.
EMAIL STATUS ALERTS
ALL
Is it possible to configure the MFP to
send only a single email alert for each
alert condition?
To enable single email alert notification for Customer
Email address only, configure the following soft switch:-
SIM 55-03 SW28-3 (change from 0 to 1).
Note: For dealer email address, multiple email
notifications will still be received.
Configuring Toner Low Email alerts to
be sent at a specific toner remaining
level
If you wish to receive toner low emails at a specific toner
remaining level, configure the MFP as follows:-
1.
Enter Simulation 26-69.
2.
Change Item F (Toner E-Mail Alert) from 1 to 0.
3.
Set Item B (Remaining Toner Level) to the
specified.
specified.
4.
level when the Email alert is sent:-
Examples: 0= 5%, 1=10%, 2=15%, 3=20%,
4 = 25% (Default), 5=30%.
Examples: 0= 5%, 1=10%, 2=15%, 3=20%,
4 = 25% (Default), 5=30%.
Note: Depending on Model, the details within Simulation
26-69 may differ therefore please refer to the Service
Manual for the relevant model series.
Click on the first or last page to see other MX-M654N / MX-M754N (serv.man2) service manuals if exist.