MX-M310, MX-M310N (serv.man9). MX-PB12 Setup Guide. - Sharp Copying Equipment User Guide / Operation Manual. Page 8

To connect the machine to a network, connect the LAN cable to the machine's network connector. 
Use a shielded LAN cable.

After connecting the machine to a network, be sure to configure the IP address and other network 
settings before installing the software. (The factory default setting for the IP address is to receive the 
IP address automatically when the machine is used in a DHCP environment.)
Network settings can be configured using "Network Settings" in the administrator settings on the 
machine.

X Checking the IP address of the machine

You can check the IP address of the machine by printing out the "PRINTER SETTINGS LIST" in the 
system settings. Follow these steps to print out the "PRINTER SETTINGS LIST".
Press the [SYSTEM SETTINGS] key, touch the [LIST PRINT] key, touch the [PRINTER TEST PAGE] 
key, and then touch the [PRINTER SETTINGS LIST] key.

The machine can be connected to a computer using a USB cable if the computer is a Windows 
computer. (The USB interface on the machine cannot be used in a Macintosh environment.)
The machine and computer must be connected when a message appears during installation of the 
printer driver. If a USB cable is connected before the printer driver is installed, the printer driver will not 
be installed correctly. For the procedure for connecting a USB cable, see "WHEN THE MACHINE 
WILL BE CONNECTED WITH A USB CABLE" (page 17).

• If the machine is used in a DHCP environment, the IP address of the machine may change. If this 

happens, printing will not be possible. This problem can be avoided by using a WINS server or by 
assigning a permanent IP address to the machine.

• This manual explains how to set up the software in a Windows network environment and in a 

Macintosh network environment.

Setup_multi.book  6 ページ  ２００９年７月７日　火曜日　午後２時８分