MX-M202D (serv.man4). Installation Manual Updated December 2013. - Sharp Copying Equipment Service Manual (repair manual). Page 37

MX-M232D  (ADJUSTMENT) 12 - 7

4) After completion of warming up, shading is performed and the 

current off-center adjustment value is displayed on the LCD.

5) Enter the set value and press the start key.

 

The set value is stored and a copy is made.

1) Set a test chart (UKOG-0162FCZZ) on the OC table as shown 

below.

2) Put several sheets of A3 or 11" x 17" white paper on the test chart. 
3) Execute SIM 46-2.
4) After completion of warming up, shading is performed, and the 

current density level is displayed on the LCD. 

Use the cross cursor to select a mode.

5) Change the set value with the 10-key to adjust the copy image 

density.

6) Make a copy and check that the specification below is satisfied.
 

Adjustment 

mode

SIM

Display 

text 

array

Set value

Specifi-

cations

Set 

range

Document off-
center (OC 
mode)

50-12

OC

+1 

 

Shifted to R 
side by 
+0.mm.
-1 

 

Shifted to L 
side by 
0.1mm.

Center ± 

2.0%

1 - 99

Sim50-12 ORG. CENTER

1:OC
2:SPF(SIDE1)
3:SPF(SIDE2)

     [      1-  99]

50

50
50

50

Sim46-2 EXP LEVEL

1:AE
2:TEXT
3:PHOTO 1
1/2     [      1-  99]

50

50
50

50

Sim46-2 EXP LEVEL

4:PHOTO 2
5:TEXT(TS)
6:AE(TS)
2/2     [      1-  99]

50

50
50

50

Density 

mode

Display 

text 

array

Expo-

sure 

level

Sharp Gray 

Chart output

Set value

Set 

range

Auto-
matic

AE

-

“2” is slightly 
copied. 

The greater the set 
value is, the darker 
the density is.
The smaller the set 
value is, the lighter 
the density is. 

1 - 99

Text

TEXT

3

“3” is slightly 
copied. 

Photo 
(Error 
diffu-
sion)

PHOTO
1

3

“2” is slightly 
copied.

Photo 
(Dither)

PHOTO
2

3

“2” is slightly 
copied.

Toner 
save 
(Text)

TEXT 
(TS)

3

“3” is slightly 
copied.

Toner 
save 
(Auto-
matic)

AE(TS)

-

“2” is slightly 
copied.