MX-M202D (serv.man4). Installation Manual Updated December 2013. - Sharp Copying Equipment Service Manual (repair manual). Page 3

MX-M232D  (GENERAL) 1 - 1

The label (

 

) in the fusing area of the machine indicates the 

following:

 : Caution, risk of danger
 : Caution, hot surface

•The fusing area is hot. Exercise care in this area when removing misfed 

paper.

•Do not disassemble the laser unit. Do not insert a reflective material 

such as a  screwdriver in the laser beam path.

 

It may damage eyes by reflection of laser beams.

•Do not switch the machine rapidly on and off. After turning the machine 

off, wait 10 to 15 seconds before turning it back on.

•Machine power must be turned off before installing any supplies.
•Place the machine on a firm, level surface.
•Do not install the machine in a humid or dusty location.
•When the machine is not used for a long time, for example, during 

prolonged holidays, turn the power switch off and remove the power 
cord from the outlet.

•When moving the machine, be sure to turn the power switch off and 

remove the power cord from the outlet.

•Do not cover the machine with a dust cover, cloth or plastic film while 

the power is on. Doing so may prevent heat dissipation, damaging the 
machine.

•Use of controls or adjustments or performance of procedures other than 

those specified herein may result in hazardous laser radiation 
exposure.

•The socket-outlet shall be installed near the machine and shall be easily 

accessible.

Improper installation may damage the machine. Please note the 
following during initial installation and whenever the machine is moved.

Caution : If the machine is moved from a cool place to a warm place, 

condensation may form inside the machine. Operation in this 
condition will cause poor copy quality and malfunctions. Leave 
the machine at room temperature for at least 2 hours before 
use.

•damp, humid, or very dusty

•poorly ventilated

•exposed to direct sunlight

•subject to extreme temperature or humidity changes, e.g., near an air 

conditioner or heater.

The machine should be installed near an accessible power outlet for 
easy connection and disconnection.
Be sure to connect the power cord only to a power outlet that meets the 
specified voltage and current requirements. Also make certain the outlet 
is properly grounded.

Note : Connect the machine to a power outlet which is not used for other 

electric appliances. If a lighting fixture is connected to the same 
outlet, the light may flicker.

Be sure to allow the required space around the machine for servicing 
and proper ventilation.

20 cm 

(8")

20 cm 

(8")

20 cm (8")