MX-LC12 (serv.man3). MX-LC12 Installation Manual - Sharp Copying Equipment Service Manual (repair manual). Page 6

MX-7040N  MX-LC12 (LARGE CAPACITY TRAY)  4 – 6

Since the off-center adjustment is performed when shipping, there
is basically no need to perform this adjustment. If the center is
shifted, however, the simulation is normally used. If the shift is not
removed, perform the following adjustment procedures.
1)

Slowly pull out the tray until it stops.

2)

Loosen the stopper fixing screw (1 pc) on the right lower side
of the tray so that the stopper does not function.

3)

Pull out the tray again until it stops.

a. When the shift is in the front side
To adjust the print line in the direction A from the paper center as
shown in the figure:
1)

Loosen two fixing screws (red screws) of the front/rear size
guide adjustment plate, and move the size guide adjustment
plate in the direction A (R side) by the shift amount, and tighten
the red fixing screws (2 for each). Move the auxiliary guide in
the direction A by the same size.

Slightly push the tray, restore the stopper to the original posi-
tion, and fix the fixing screw.
Check to insure that the stopper pawl is engaged with the stop-
per reception of the large capacity tray.

2)

Slowly insert the tray to the original position.
Then make a copy to check to insure that there is no more
shift. Repeat the procedures until there is no shift.

A

R side

F side