Read Sharp MX-GBX1 Service Manual online
45
6.4 PUNCHING
OPERATIONS
After installing the correct die set in your SmartPunch, you are ready to begin punching. The following
sections indicate how to activate the machine. Read these sections completely and become familiar
with the various machine and Die Set components.
sections indicate how to activate the machine. Read these sections completely and become familiar
with the various machine and Die Set components.
The POWER LED should be illuminated. If not, apply power with the Power On/Off (I/O) switch located
at the front of the SmartPunch module.
at the front of the SmartPunch module.
PUNCH ENABLED: You activate the punch by using the Multi-function printer interface screen.
Once punch is enabled, the LED will remain illuminated and the punch will remain enabled for one full
minute after the run has ended. After that time, the system will default to the bypass mode and the next
run will not be punched.
minute after the run has ended. After that time, the system will default to the bypass mode and the next
run will not be punched.
CLOSE DOOR and PAPER JAM: If either of these LED’s are on, no bypass and no punch can occur
until these areas have been checked and corrected.
until these areas have been checked and corrected.
CHIP TRAY FULL/OUT and CHECK DIE SET: If either of these LED’s is on, you can run in bypass
mode but not punch mode.
mode but not punch mode.
CHIP TRAY FULL/OUT: If this LED is flashing the Chip Tray is FULL. If this LED is shinning solid, the
Chip Tray is OUT.
Chip Tray is OUT.
POWER: If this LED is not on, paper can not run through the GBC SmartPunch in either bypass or
punch mode. The paper will jam entering the GBC SmartPunch.
punch mode. The paper will jam entering the GBC SmartPunch.
6.5 PAPER CHIP DRAWER
The paper chip drawer for your SmartPunch is located at the front of the machine’s base. The drawer
should be periodically pulled out and emptied. The SmartPunch incorporates microprocessor
technology to inform the operator when the Chip Tray needs to be emptied. When the Punch has cycled
4000 times, the Check Chip Tray LED will begin to flash on and off. You may continue to use the
SmartPunch for a short period longer if you wish, but it is not recommended.
should be periodically pulled out and emptied. The SmartPunch incorporates microprocessor
technology to inform the operator when the Chip Tray needs to be emptied. When the Punch has cycled
4000 times, the Check Chip Tray LED will begin to flash on and off. You may continue to use the
SmartPunch for a short period longer if you wish, but it is not recommended.
You must empty the Chip Tray with the Power On so that the sensors are able to identify this action.
This will ensure that the LED will reset itself.
This will ensure that the LED will reset itself.
BINDER SIDE
FINISHER SIDE
B
A
Click on the first or last page to see other MX-GBX1 service manuals if exist.