MX-GBX1. Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 16

16 

What you need to service the GBC SmartPunch: 

1.  Standard Measure Tools (English as opposed to metric) 

a.  Nut Driver, 5/16” (optional use Phillips head) 
b.  Nut Driver, 1/4” (optional use Phillips head) 
c.  Allen Wrench, 3/32”  
d.  Allen Wrench, 5/64” 
e.  Allen Wrench, 9/64”  

2.  Other recommended tools 

a. Needle 

Nose 

Pliers 

b.  E-Prom Extractor Tool

 

c. Wire 

Cutters 

d. Screw 

Driver, Phillips Head 

e.  Screw Driver, Flat Head, Small 

3.  Supply of Wire Tie Wraps 

A nut driver head of ¼” is the most common size for the barrel of a Magnetic or 
interchangeable tip screwdriver.  

 

The die set position cradle is set in the factory; however, because of the punched-hole spacing on the PB 
die sets, there is a minimal amount of paper on each edge of the punched paper. The die set position 
cradle may have to be fine adjusted to center the punched-hole pattern in the paper. 

Listed below are the step-by-step instructions to adjust the die set to the proper position: 
•  The punched-hole alignment must be checked on a piece of punched paper. Fold the punched sheet of 

paper in half and the punched-holes should be aligned. If the punched-holes are not aligned, then the 
die set cradle must be adjusted to align the punched holes.  

The paper path is always constant, if the holes are not centered, you must adjust the die 
set cradle.