MX-FNX3, MX-FNX4. MXFNX3 and MXFNX4 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 108

MX-FNX4  DISASSEMBLY AND ASSEMBLY  6 – 65

2) Hold the pawl of the two tie wraps with lock [1], and remove

them. (Remove without cutting the tie wraps.)

3) Disconnect the three connectors [2].
4) Remove harness [4] from the three harness holders [3].

5) Turn the gear [1] into the arrow direction, and move the punch

module [2] to the front side.

6) Remove the three screws [1] and the sensor base (upper) [2].
7) Then, disconnect the connector of the photo sensor PCB [3]

and the connector of the LED PCB [4], and remove the har-
ness from the edge saddle [5].

8)

Remove the harness [2] from the four harness holders [1].

9)

Disconnect the connector of the horizontal registration motor
[1] and the connector of the horizontal registration sensor [2],
and remove the punch module harness.

[2]

[1]

[2]

[3]

[3]

[1]

[3]

[4]

[1]

[2]

[2]

[1]

[1]

[3]

[1]

[1]

[2]

[1]

[2]

[1]