MX-FNX10. MX-FN10 Service Manual (Complete) - Sharp Copying Equipment Service Manual (repair manual). Page 22

MX-FN10  DISASSEMBLY AND ASSEMBLY  6 – 3

1)

Loosen the screw [1].

2)

Remove the right lower cover.

1)

Remove the load tray. (See (1).)

2)

Remove the saddle paper holding lever. (See (2).)

3)

Remove the saddle tray. (See (3).)

4)

Remove the front cabinet. (See (4).)

5)

Remove the rear cabinet upper. (See (5).)

6)

Put the load tray supporting plate (front) [1] and the load tray
supporting plate (rear) [2] outside of the rail groove.
Note: When the load tray is on the top position, lower the load 

tray by manually turning the load tray lift motor rotation 
shaft (counterclockwise) so that the sensor flag attached 
to the supporting plate (rear) does not make contact with 
the load tray upper limit sensor.

7)

Open the center binding staple replacement door, and release
the center binding staple lock.

8)

Disconnect two connectors on the left side of the side guide
upper.

9)

Remove the side guide upper.

1)

Remove the side guide upper. (See (10).)

2)

Remove the side guide lower.

NOTE: When assembling, place the polyester film (2 positions) on

each side of the side guide lower and attach.

[1]

[1]

[2]