MX-FN19, MX-FN20, MX-PN12. All Sections - Sharp Copying Equipment Specification (repair manual). Page 16

MX-FN19  ADJUSTMENTS AND SETTINGS  3 – 3

Use the user mode of the host machine for this adjustment.

1) Open the front cover.
2) Pull out the stitcher base unit to the front, and pull the stitcher

handle [1] once and raise the stitcher.

3) Remove the three screws [2], and remove the stitcher cover

[3].

4) Remove the positioning tool [4] attached to the back of the

cover.

5) For adjustment of the stitcher in the front side, remove the front

guide plate [5] and the center guide plate [6]. For adjustment of
the stitch in the rear side, remove the center guide plate [6]
and the rear guide plate [7]. (one screw, each)

6)

For adjustment of the stitcher in the front side, loosen the two
screws [9] of the stitcher base [8]. For adjusting of the stitcher
in the rear side, loosen the two screws [10] of the stitcher base
[8].

7)

Insert the tool [12] into the staple slot of the stitcher [11].

8)

Tilt the stitcher. Then, rotate the stitch gear [13], fit the tool [14]
and the concave section of the base [15], and tighten the
screw of the base [15] to fix.

[1]

[3]

[4]

[7]

[6]

[5]

[10]

[9]

[8]

[11]

[12]

[15]

[14]

[13]