Read Sharp MX-CF11 / MX-6240N / MX-7040N Specification online
MX-CF11 REPLACEMENT AND ADJUSTMENT 3 – 7
7. ROLLERS
A. SEPARATION ROLLER
• 1st (or 2nd) feed unit (
3.FEED UNITS)
[A] Cover
[B] Separation Roller (
[B] Separation Roller (
x1)
B. FEED BELT UNIT AND PICK-UP ROLLER
• Open the 1st tray cover.
[A] Feed belt unit
[A] Feed belt unit
• The unit is spring loaded. Push it to the right to release it, then
lift it out.
[B] Pick-up roller (
x 2, bushings x 2)
C. FEED BELT
• Feed belt unit (
7. ROLLERS - B.)
[A] Pick-up roller unit.
• Pull the unit away from the bushings in the direction of the
arrow.
[B] Feed belt holder
• Hold the feed belt holder by the sides, then lift up to separate
from the holder.
• Pull slowly to avoid losing the springs.
[C] Feed belt.
Re-assembly
1)
1)
Position the pick-up roller unit [A] and feed belt holder [B] as
shown above.
shown above.
2)
On the rear side, slide out the bushing, and rotate guide plate
[D] until its stepped side attaches at [E] as shown above, then
snap the guide plate on.
[D] until its stepped side attaches at [E] as shown above, then
snap the guide plate on.
3)
On the front side, rotate guide plate [F] until its flat side is par-
allel with [D], then snap it on. Viewed from the bottom, the
plates must be aligned.
allel with [D], then snap it on. Viewed from the bottom, the
plates must be aligned.
[A]
[B]
[A]
[B]
[A]
[B]
[D]
[E]
[C]
[F]
Click on the first or last page to see other MX-CF11 / MX-6240N / MX-7040N service manuals if exist.