Read Sharp MX-C300P / MX-C300PE / MX-C300PL (serv.man3) Service Manual online
MX-C300P MX-CS11 (500 SHEET PAPER FEED UNIT) 3 – 1
MX-C300P
Service Manual
[3] MX-CS11 (500 SHEET PAPER FEED UNIT)
1. Installation
<Precautions for installation>
Before execution of installation, check to confirm that the data lamp
under it are not lighted or blinking.
under it are not lighted or blinking.
A. Turn off the power of the main unit
1)
Check to confirm that the operation panel is turned OFF, and
then turn OFF the power switch.
then turn OFF the power switch.
2)
Disconnect the power plug from the power outlet.
B. Install the main unit to the MX-CS11.
NOTE: If the main unit is combined with the MX-CS11, it must
be used as a desktop machine and must not be used on
the floor in order to prevent against falling.
the floor in order to prevent against falling.
1)
Put the main unit on the MX-CS11 so that they fit together.
NOTE: When holding the main unit, use two persons.
NOTE: When lifting / holding the main engine, never lift. Lift
the engine at the right and left cover bottoms using the hand
grab indentions provided.
the engine at the right and left cover bottoms using the hand
grab indentions provided.
2)
Pull out the trays of the main unit and MX-CS11.
3)
Attach the main unit and MX-CS11 with the plates (Packed
item Plate A) and the screws (Packed items M4x10 P Tight
and M4x8 S Tight).
item Plate A) and the screws (Packed items M4x10 P Tight
and M4x8 S Tight).
4)
Remove the Rear cover. .
5)
Attach the main unit and MX-CS11 with the plates (Packed
item Plate B) and the screws (Packed items M4x10 P Tight).
item Plate B) and the screws (Packed items M4x10 P Tight).
C. Turn on the power of the main unit
1)
Power to the main unit.
2)
Turn ON the power switch.
2. Adjustments
A. Image off-center automatic adjustment
(Document table mode)
1)
Enter the SIM50-10 mode.
2)
Set A4 (11" x 8.5") paper in each paper feed tray.
3)
Press [OK] key.
The adjustment pattern is printed out. (Paper is fed from the
paper feed tray.)
paper feed tray.)
Perform the procedures of 2) - 3) for the printed adjustment
pattern of each paper feed tray.
pattern of each paper feed tray.
4)
Press [OK] key.
The adjustment result becomes valid.
A
D
A
C
B
D
D
B
D
D
6LP3$3(52))6(7
㸸
%.0$*
㸸0$,10)7
㸸
>@
㸸
>@
(;(&
0$,1&6
6LP3$3(52))6(7
㸸
%.0$*
㸸0$,10)7
㸸
>@
㸸
>@
(;(&
0$,1&6
Click on the first or last page to see other MX-C300P / MX-C300PE / MX-C300PL (serv.man3) service manuals if exist.