Read Sharp MX-C300P / MX-C300PE / MX-C300PL (serv.man3) Service Manual online
MX-C300P/MX-C300PE/C300PL (MAIN UNIT) 2 – 3
C. Fusing unit lever
1) Open the right door unit..
2) Turn the levers of the Fusing unit to add the pressure.
2) Turn the levers of the Fusing unit to add the pressure.
* Only the levers can add or release the pressure. There is no
screw for adding or releasing the pressure.
NOTE: When the machine is left for one month without using, the
Fusing heat roller could be deformed. If the machine is not
going to be used for an extended period, release the pres-
sure on the fusing rollers.
D.Tray size setup
1) Gently pull out the tray until it stops. If paper is in the tray,
remove it.
2) Adjust the guide plates A and B to the vertical size and the hori-
zontal size of paper.
The guide plates A and B are movable. Hold the fixing knob to
The guide plates A and B are movable. Hold the fixing knob to
slide the guide plates A and B to match the paper size.
3) Insert the tray slowly.
4) Turn ON the machine and press the [SPECIAL FUNCTION]
key on the LCD, and press the [UP] or [DOWN] key to select
"Paper Size Set".
E.Specifications setting
Use SIM26 to set to the specifications according to the customer's
request.
To customize one of the following items after destination setting,
change the set value of the item.
F.Paper fixing
The Paper fixing is not bundled with the machine. When the follow-
ing cases occur, it is recommended to use the Paper fixing.
The parts code of Paper fixing : LFIX-0627FCZ1
a. Even if the Output tray extension is used, the fed paper falls off
from the output tray.
The customer does not like to use the Output tray extension.
(1)
(2)
(2)
(2)
0LATE
0LATE
SIM No
Content
26
6
Destination setting
SIM No
Content
26 18 Toner save mode enable/disable setting
* For the other destinations, this setting is made by
the user program.
53 Auto color calibration enable/disable setting
Paper fixing
Click on the first or last page to see other MX-C300P / MX-C300PE / MX-C300PL (serv.man3) service manuals if exist.