Read Sharp MX-BMX1 (serv.man9) User Guide / Operation Manual online
6
52
Load covers
Code CF-501 is displayed when covers run low.
Code CF-501 is displayed when covers run low.
If you wish to continue production:
Load more cover sheets according to section 2. Making Booklets.
Code CF-501 will extinguish and copier will start.
If you wish to continue production, using up the cover sheets that are loaded:
Press ESC. Code CF-501 will extinguish and copier will start.
Code CF-401 is displayed when covers are empty.
If you wish to continue production:
Load more cover sheets according to section 2. Making Booklets.
If cover job is finished and you wish to run a new job without covers:
Select Cover Off in the Cover menu.
Open and Close MX-BMX1 Top Cover.
Double feed
This message will be displayed when the Cover Feeder detects that more than one cover
This message will be displayed when the Cover Feeder detects that more than one cover
was fed from the cover bin. If more than one cover was fed, check cover loading according to
section 2. Making Booklets. If the covers that are fed are thick, with dark print or with mixed
prints on the covers, double feeding may be displayed even if that is not the case. Turn off
double sheet detection according to section 3. Tools.
Misfeed
This message will be displayed when the Cover feeder could not feed a cover from the paper
This message will be displayed when the Cover feeder could not feed a cover from the paper
bin. Check cover loading according to section 2. Making Booklets. If problem persists, clean
separator pad according to section . REMARKS.
Cover feeder fault codes
Trim bin full
This message will be displayed when the trim bin is full or when a trim strip, due to static
This message will be displayed when the trim bin is full or when a trim strip, due to static
electricity, is prevented from falling down into the trim bin. Empty the trim bin and remove loose
trim strips from inside the Trimmer. See section 1. Basics for how to remove the trim bin.
Close trimmer belts
This message will be displayed when the belts at the outfeed area of the Trimmer is not in
correct position. Open cover and set Trimmer belts to their lower position. Close cover.
Click on the first or last page to see other MX-BMX1 (serv.man9) service manuals if exist.