Read Sharp MX-BMX1 (serv.man9) User Guide / Operation Manual online
6
51
Booklet maker fault codes
Check staples
Trimmer fault codes
This message will be displayed when a staple cartridge is empty or when stapling could not
be performed. Check in the following order:
– If a staple cartridge is empty, replace according to section 1. Basics.
– If staple cartridges are OK; remove the set and check that the number of sheets is within
specifications.
– If staple cartridges are OK and set is within specifications; remove and check stapler head
according to section 1. Basics.
Set too thick
This message will be displayed when the set sent from the copier is outside Booklet Maker
specifications. Open the top cover, remove the set and close the top cover.
Oil clinchers
Oil clinchers
This message will be displayed every 20 000 stapling cycles. The purpose is to remind the
operator to maintain stapler head and clinchers. If not doing that every 20 000 there is a great
risk of a costly mechanical breakdown. See section Maintaining Your Machines on page 52
for procedure.
Remove purged sets
Remove purged sets
This message will be displayed when the purged set is in the infeed area. Open the top cover,
remove the set and close the top cover.
Illegal feed mode
If this message is displayed, contact customer support.
Stacker full
This message will be displayed when the Stacker is full. Empty Stacker.
Note
During poor environmental conditions waste from the trimming operation may be transported
through the system.
To improve the situation the trim margin may be increased and thereby ensuring that
The waste is transported into the waste bin.
Click on the first or last page to see other MX-BMX1 (serv.man9) service manuals if exist.