Read Sharp MX-BMX1 (serv.man4) Service Manual online
20 October 2010
CF-3-10
3.2.6 DRIVE MOTOR M16 ASSEMBLY
[A]
0.4 ± 0.3 mm play between
the coupling and the clutch
Removal
1. Remove complete Cover Feeder unit (
1. Remove complete Cover Feeder unit (
1.1.1).
2. Disconnect Connector [A] (
x1).
3. Remove Drive motor M16 assembly by removing screws [B] ( x2).
NOTE: Be careful when removing the Drive motor M16 assembly, so that the
Drive Shaft Assembly will not damage the LED sensor CF-Q30 (
3.1.2).
4. Loosen the allen screw [C] to Drive clutch assembly ( x1).
5. Remove the motor bracket by removing screws [D] ( x3).
5. Remove the motor bracket by removing screws [D] ( x3).
[B]
[C]
[D]
Replacement
1. Reverse the removal procedure.
2. Enter Service mode (
1. Reverse the removal procedure.
2. Enter Service mode (
5.1.1 in MX-BMX1 Service Manual).
3. Perform Cover Feeder motor calibration (
5.5 in MX-BMX1 Service Manu-
al).
Adjustment
Adjust the Drive clutch assembly, so that there is play between the coupling on the
Adjust the Drive clutch assembly, so that there is play between the coupling on the
Drive shaft and the Clutch. The play should be 0.4 ± 0.3 mm. Adjust by loosening
screw [C].
AREA F
[C]
Click on the first or last page to see other MX-BMX1 (serv.man4) service manuals if exist.