Read Sharp MX-B381 / MX-B401 (serv.man8) Service Manual online
MX-B381/B401 DEHUMIDIFIER HEATER KIT (SERVICE PARTS) FOR THE MX-CSX1/CSX2 14 – 2
5)
Press the right side (left side when viewed from the rear) of the
desk rear cabinet and pull the rear cabinet to the rear.
desk rear cabinet and pull the rear cabinet to the rear.
B. Heater interface PWB installation
* The descriptions are made on the MX-CSX1. If the MX-CSX2 is
also installed, perform the same procedures for the MX-CSX2.
1)
Insert the PWB supporter (No.2) into the left side of the desk.
(4 positions)
* Insert the edge with flange into the desk.
(4 positions)
* Insert the edge with flange into the desk.
2)
Insert the heater Interface PWB (No.4) into the PWB sup-
porter.
porter.
C. Connect the main unit and the MX-CSX1.
* This procedure is required only for the MX-CSX1, and is not
required for the MX-CSX2.
* When only the MX-CSX1 is installed, the WH desk I/F harness
(No.6) is not used.
1)
Pass the red connector side of the WH Frontier I/F harness
(No.7) through the clearance shown in the figure below to the
heater interface PWB on the left side.
(No.7) through the clearance shown in the figure below to the
heater interface PWB on the left side.
2)
Connect the WH Frontier I/F harness (No.7) to CN-A of the
heater interface PWB (No.4).
heater interface PWB (No.4).
3)
Attach the mini clamp (No.3) to the MX-CSX1.
4)
Insert the snap band attached to the WH Frontier I/F harness
into the MX-CSX1.
into the MX-CSX1.
5)
Hang the WH Frontier I/F harness on the notch section of the
cabinet of the MX-CSX1.
cabinet of the MX-CSX1.
6)
Pass the WH Frontier I/F harness to the saddle.
7)
Connect the WH Frontier I/F harness connector to CN4 of the
WH PWB of the main unit.
WH PWB of the main unit.
Click on the first or last page to see other MX-B381 / MX-B401 (serv.man8) service manuals if exist.