MX-B200 (serv.man8). Operation Manual. - Sharp Copying Equipment User Guide / Operation Manual. Page 74

Simultaneous use of two or more application software 
programs.
→ Start printing after quitting all unused application 

software programs.

–

The paper is loaded so that printing takes place on the 
rear side of the paper.
→ Some paper types have a front and rear side. If the 

paper is loaded so that printing takes place on the rear 
side, toner will not adhere well to the paper and a good 
image will not be obtained.

You are using paper that is outside the specified size 
and weight range.
→ Use copy paper within the specified range.

Paper curled or damp.
→ Do not use curled or crimped paper. Replace with dry 

copy paper. During periods when the machine is not 
used for a long time, remove the paper from the tray 
and store it in a dark place in a bag to prevent moisture 
absorption.

–

You did not set sufficient margins in the paper settings 
of your application.
→ The top and bottom of the paper may be dirty if the 

margins are set outside of the specified print quality 
area.

→ Set the margins in the software application within the 

specified print quality area.

–

The paper loaded in the tray is not the same size as 
that specified in the printer driver.
→ Check if the "Paper Size" options suit the size of the 

paper loaded in the tray.

→ If the "Fit To Paper Size" setting is activated, make sure 

that the paper size selected from the drop-down list is 
the same as the size of the loaded paper.

–

The orientation of document setting is not correct.
→ Click the "Main" tab in the printer driver setup screen, 

and verify if the "Image Orientation" option is set to 
your requirements.

–

Paper is not loaded properly.
→ Make sure the paper is properly loaded.

You did not correctly specify the margins for the 
application in use.
→ Check the layout of the document margins and the 

paper size settings for the application you are using. 
Also check if the print settings are specified correctly to 
suit the paper size.

–

The setting for the print density is not appropriate. 
→ You can adjust the print density on the printer driver. 

Click the "Advanced" tab in the printer driver setup 
screen, and click the "Compatibility" button. Select the 
"Print Density Level" from 1 (light) to 5 (dark).

–