MX-6580N, MX-7580N (serv.man2). MX7580N - Handy Guide Version 1 May 2017 - NOTE - Handy Guides are NOT a substitute for Service Manuals and Parts Guides - Sharp Copying Equipment Handy Guide. Page 57

 

 

14  FSS function connection test mode set 
15  FSS connection status display 
16  FSS alert send setting 
17  FSS paper order alert setting 

 

01  Main unit sensor check 
02  Paper feed sensor check (main body) 

 

02  Bypass tray width adjustment 
07  Bypass tray width detection manual setting 
12  Tray 4 width detection adjustment 

 

01  Document sensor operation check 
02  Document sensor output setup 
03  Document sensor output display 

 

01  Fuser temperature setup for each mode 
02  Fusing operation and preheat setting 
20  Fuser temperature. correction for low 

temperature & humidity (L/L) 

21  Fuser temp correction for high temperature 

& humidity (H/H) 

24  Fuser temperature correction setting 

31  Fusing web cleaning motor operation check 
32  Set forcible operation of fusing web cleaning 

at job end 

35  Fusing NIP operation check 

 

01  Process control mode setting 
02  Process control sensitivity adjustment 
04  Process control initial density setup  
06  High density process control correction  
09  Process control data display 
12  High density process control and image 

sensor data display 

14  Fuser temp.& humidity output data 
15  OPC drum idle rotation setting 
17  Process refresh execution 
21  Half tone process control registration target 
22  Half tone process control operation result 
24  Half tone process control operation 

correction data result display 

25  Initial half tone correction data display 
26  Half tone process control execution 
27  Half tone process control correction clear 
28  Process control timing (On/Off) setting 
29  Enable/disable half tone correction during 

each job 

31  OPC drum deflection adjustment/check 
37  DV bias correction level setting for 

continuous print mode. 

43  DV unit installation identification check 
62  Process control execution condition setting 

 

01  Colour copy density adjustment 
02  B/W copy density adjustment 
04  Image Send Colour scan density adjustment 
05  Image Send B/W scan density adjustment 
08  Colour scanner balance adjustment RGB 
09  Scan image density adjustment 
10  Copy colour balance & gamma manual 

adjustment  

16  B/W copy density & gamma adjustment 
19  B/W auto exposure mode setup 
21  Copy colour balance adjustment (All) 
23  Enable/disable maximum density adjustment 

for copy mode 

24  Copy half tone auto adjustment 
25  Single colour mode colour balance set-up 
26  Single colour mode colour balance reset 
27  Coefficient (Black edge) gamma set-up 
30  Resolution adjust (sub-scan – copy mode) 
32  Document background density adjustment 
36  2-colour mode adjustment (Red, Black) 
37  B/W image reproduction adjustment 
38  Black component adjustment (Copy mode) 
39  Fax Image send sharpness adjustment 
40  Fax mode exposure adjust (All modes) 
41  Fax mode exposure adjust (Normal) 
42  Fax mode exposure adjust (Fine Text) 
43  Fax mode exposure adjust (Super Fine) 
44  Fax mode exposure adjust (Ultra Fine) 
45  Fax mode exposure adjustment (600dpi) 
46  Fax mode exposure adjustment (RGB RIP) 
47  JPEG compression rate setting  
48  Function setting for copy output 
51  Heavy paper mode gamma adjustment 
52  Heavy paper mode gamma default set