MX-6240N, MX-7040N (serv.man16). Installation Manual (Revised May 2017). - Sharp Copying Equipment Service Manual (repair manual). Page 13

MX-7040N  MX-6240N/7040N (MAIN UNIT)  2 – 3

1)

Remove the optical unit fixing screw, and remove the note
label.

1)

Attach the operation panel mounting plate (Packed items) to
the operation panel (Packed items), and fix by the screw (M3 x
8 S-tight) (Packed items). Attach the operation section cover B
(Packed items), and fix by the screw (M3 x 8 S-tight) (Packed
items).

2)

Open the right door.

3)

Remove the screw and remove the upper cabinet front right.
Disconnect the connector from the USB I/F PWB.

4)

Remove the screws and remove the front cabinet upper.

5)

Attach the operation panel by fixing the screws (M4 x 8 S-tight)
(Packed items).

6)

Attach the wire saddle (S) and wire saddle (M), and fix the har-
ness to the wire saddle.

NOTE: Check to confirm that the harness does not enter the

panel. 
For the reference, refer to the figure below.

1

1

2

1

2

2

2