MX-6240N, MX-7040N (serv.man16). Installation Manual (Revised May 2017). - Sharp Copying Equipment Service Manual (repair manual). Page 12

MX-7040N  MX-6240N/7040N (MAIN UNIT)  2 – 2

1)

Put the height adjuster plate (Packed items) under the adjuster
bolt at the bottom of the machine. 
Turn the adjuster bolt to adjust the height and the tilt of the
machine.

MEMO: When the adjuster bolt is turned counterclockwise, the
height is decreased. When turned clockwise, the height is
increased. (Common to the options the height of which is
adjusted by the adjuster bolt.)

NOTE: Lower the height of the MX-CF11 to the lowest position

before adjusts the level between the MX-CF11 and the
main body.

Adjust the height of the top surface of main body refer-
ence to the top surface of the MX-CF11.

1)

Pull out the tray1/2. Remove the screw, and remove the cau-
tion label. 
Close the tray which was pulled out.

2)

Pull out the tray 3 and tray 4. Turn the fixing material and
remove it. Remove the caution label. 
Attach the removed fixing material to the position shown in the
figure for future use. 
Close the tray which was pulled out.

Low

High